Finally, a good stretch of time last weekend and the mental state needed to get back to work on Shelter. The photo above is one section of the turquoise tier, just basted for now, but I'm liking it.
The problem comes as I move across into bigger areas. There is going to be some "stubbiness." I think the piece about in the middle above that ends in a stub is OK, but that the piece that starts with a stub, below the top edge of the tier (like the light green piece) is not. This section further is pinned only, not basted, so no problem making changes. I might try changing the angle of the stub, but it will probably be better to have everything either start from the top edge, or be tucked under another piece. If you are able to follow this somewhat convoluted description and have any suggestions, I'd be glad to know them!Another challenge is that this tier is so much larger than the dark blue tier that I can't use the same construction process. For the smaller one, I pinned the whole thing up on the design wall, and then moved it back and forth from table to wall to work and look, work and look. This is too big for that, so I am having to work on it just on the table, relying on a stepladder for getting some distance on it. I also am attaching the turquoise strips directly to stabilizer, which I didn't do for the blue piece (though I had the stabilizer cut, and basted the fully pieced blue tier to the stabilizer once it was done). So, more bricolage, figuring things out as I go along.
And in case you're curious about the big project at work that kept me so busy all summer and into the fall, you can see the end product here.
